Pick a color
Boxed/Wide
Boxed
Wide
Content width
1200
1040
960
Select headings font
Background (Boxed)
Accelerator-Hydraulic Relay
Description
Is designed for operating hydraulic valves at certain distances, in which the hydraulic signal it is not enough or too high to operate them.
- It also enables other functions such as: hydraulic control relay(normally open or normally closed), to open and close hydraulic valves.
- Accelerator of opening or closing the valve.
- command for topographical differences in height, etc.
Materials | |
Body and cover | Brass |
Screw, nut | Stainless steel |
| Spring | Stainless steel |
| Diaphragm | Natural rubber |
| Shaft |
|
| Connections: | 1/4" socket BSP |
Max. Pressure: | 16 bar(232psi) |
Description of operation of the hydraulic connection relay depending on the hydraulic valve.
Productos relacionados
Three Way Valve
Vista previa
Ver detalles
Three Way Valve
Description The function of the 3-way valve is to make the hydraulic valve in which it is installed, regardless of that function, to act in the manual position for opening and closing or acting automatically.There are four models: Characteristics Materials Body Brass Threaded side 1/8” female BSP Main connection 1/4” male BSP 1/4” female BSP
Brass Filter
Vista previa
Ver detalles
Brass Filter
Description The intake filter for hydraulic valve, removes impurities that may reach the hydraulic circuit, helping to correct operation. Characteristics Materials Body Brass Mesh Stainless steel Connection 1/4” Length 50mm38mm
Plastic Filter
Vista previa
Ver detalles
Plastic Filter
Description The intake filter for hydraulic valve, removes impurities that may reach the hydraulic circuit, helping to correct operation. Characteristis Materials Body Plastic Mesh Stainless steel Connection 1/4” Length 60mm
Needle Valve
Vista previa
Ver detalles
Needle Valve
Description The needle valve allows to manually regulate the closure of the passage section. Characteristics Materials Body Brass Threaded side 1/4” female BSP Shaft Brass Nut Brass O-ring EPDM
Selector T 1/8″
Vista previa
Ver detalles
Selector T 1/8″
Description Is a pressure selector valve which selects the greater pressure between two sources of control. Characteristics Materials Body Brass Connections 1/8” Posición de trabajo (Work position):PA higher than PBPosition BPA lower than PBPA,PB: control pressure
Grooved Coupling
Vista previa
Ver detalles
Grooved Coupling
Description Designed for joining grooved ends. It provides a self-centered union and avoid the use of special supports and expansion joints. Characteristics Materials Body Cast ductile iron, with coating of epoxy-polyester paint Screw, nut Galvanised steel Seal EPDM Availablensizes 2”3”4” Max. Pressure: 16 bar(232psi)